PRODUCT SPECIFICATIONS
Laird Technologies CA100NM-MMCX-12 N Male to MMCX RF Cable
The Laird Technologies CA100NM-MMCX-12 is a 12-inch RF coaxial cable assembly with an N male connector at one end and an MMCX connection at the other. Flytec identifies the cable as LMR100 and lists an operating frequency range of 700 MHz to 5.825 GHz.
This short antenna pigtail provides an RF connection between equipment with matching MMCX and N-type interfaces. It is intended for installations where connector configuration, frequency range, cable length, and electrical requirements have been verified for the complete RF system.
Key Features
- N male to MMCX connector configuration.
- 12-inch nominal cable length, equivalent to 304.8 mm.
- LMR100-type coaxial cable construction.
- Listed frequency range of 700 MHz to 5.825 GHz.
- Short cable assembly for antenna and equipment interconnection.
RF Connectivity
The listed frequency range includes common 2.4 GHz and 5 GHz wireless applications. The connected radio and antenna must support the same operating band, and their interfaces must match the cable's connector configuration.
This passive cable carries an RF signal. It does not convert frequencies, amplify the signal, or add wireless protocol support.
Installation Considerations
Verify connector gender, polarity, impedance, RF power handling, and available clearance before installation. Route the cable without sharp bends and avoid placing mechanical strain on the MMCX connection.
For exposed installations, verify the cable assembly's environmental suitability and provide appropriate protection for the connections. No weatherproof or ingress-protection rating has been confirmed for this SKU.
Ideal Applications
- Short RF interconnections in compatible wireless equipment.
- Antenna connections requiring an N male to MMCX pigtail.
- Replacement of an existing cable with verified matching specifications.
- OEM integration and RF evaluation setups.
Compatible Products
This cable is intended for RF equipment requiring an N male to MMCX connection within the listed 700 MHz to 5.825 GHz range.
Before selecting a radio, antenna, or other RF component, verify:
- The exact mating connector type, gender, and polarity at both ends.
- Matching system impedance.
- Operation within the supported frequency range of every component.
- Adequate RF power handling for the transmitter and installation.
- Sufficient cable length, connector clearance, and acceptable RF loss.
No specific companion product has been confirmed for this exact Flytec SKU.
Important: MMCX, MCX, U.FL, SMA, and RP-SMA are different interfaces. Do not substitute cables based on similar appearance. The N male end is also different from an N female bulkhead connection.
Technical Specifications
General
- Brand: Laird Technologies
- Flytec SKU: CA100NM-MMCX-12
- Product Type: RF coaxial cable assembly / antenna pigtail
- Construction: Passive cable assembly
Connectors
- Connector 1: N male
- Connector 2: MMCX
- Connector Count: 2
Cable
- Cable Type: LMR100, as listed by Flytec; the corresponding Laird catalog entry specifies LMR100 equivalent
- Nominal Length: 12 inches / 304.8 mm
RF Specifications
- Listed Frequency Range: 700 MHz to 5.825 GHz
- Maximum RF Power: Not reliably confirmed for this exact SKU
- Insertion Loss: Exact-SKU performance across frequency not independently confirmed
Download Laird RF Cable Assembly Datasheet — Includes CA100-NM-MMCX-12 (PDF)