Tycon EZ-Bridge LT2 HD+ Industrial Strength wireless PtP Bridge System

The EZ-Bridge LT2HD+ is a high power 25dBm (316mW) outdoor wireless bridge system operating in the 2.4GHz unlicensed frequency spectrum providing real world throughput up to 100 Mb/sec. It complies with the 802.11gn standards to insure interoperability. The EZ-Bridge LT2HD+ creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight. It supports VOIP, VPN, multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-Bridge LT2HD+ units can be connected in a mesh configuration to allow interconnecting more than two sites.

With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security.

Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power inserters. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that needs to be loaded to the computer.

The EZ-Bridge LT2HD+ comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including 2 powerful 14dBi 802.11gn MIMO antennas with built-in high power electronics, Bracket Kits which accommodate pole or wall mounting, Surge Protected Cat5e rated POE (Power Over Ethernet) power inserters and 75' outoor rated shielded CAT5 cables. Customer needs to supply CAT5 cabling between the power inserter and his computer, router or switch.

FEATURES

• High Power Electronics and powerful antenna 
• True Plug and Play
• 64 and 128bit WEP, WPA and WPA2 Encryption 
• Web-based configuration
• Power over Ethernet
• Layer 2 Transparent Bridge 

BENEFITS

• Operation up to 3 miles with good line of sight and up to 100 Mbps real world throughput
• No driver needed. Pre-configured at the factory for automatic peer to peer communications
• Most powerful data security available
• Remotely change device configuration or update firmware from anywhere on the network
• Antennas can be mounted up to 100meter (300’) from the power inserter
• Appears to network devices as if an Ethernet cable has been installed between the 2 network nodes. Passes DHCP, VOIP Packets, VLAN Packets and supports multiple MAC addresses

Antenna Physical Dimensions (L x W x D)

• 314mm x 187mm x 65mm (12.4” x 7.3” x 2.5”)

Complete System Weight

• 3 kg (7 lbs )