PRODUCT SPECIFICATIONS
The EZ-Bridge® 5AC is a high power 25dBm (316mW) outdoor wireless bridge system operating in the 5GHz unlicensed frequency spectrum providing throughput up to 900 Mb/sec. It complies with the 802.11a/n/ac standards to insure interoperability. The EZ-Bridge® 5AC creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight. It supports VOIP, VPN, multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-Bridge® 5AC units can be connected in a mesh configuration to allow interconnecting more than two sites.
With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides strong wireless data security.
Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the PoE power inserters. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done thru the builtin web interface from any point on either side of the network. There are no drivers or software that needs to be loaded to the computer.
The EZ-Bridge® 5AC comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including 2 powerful 15dBi 802.11a/n/ac MIMO antennas with built-in high power electronics, Stainless Steel hose clamp to accommodate 1-2” pole (or wall mounting), 48V PoE (Power over Ethernet) power inserters with auto-ranging 120/240VAC input, and one 3ft Cat5 Ethernet patch cable. Customer needs to supply CAT5/6 cabling between the power inserter and the antenna.
FEATURES
- High Power Electronics and Powerful MIMO Antenna
- True Plug and Play
- Dual Radio – 5GHz and 2.4GHz
- 64 and 128bit WEP, WPA Encryption
- Web-based configuration
- Power over Ethernet
- Layer 2 Transparent Bridge
- Multiple SSID
- VPN
- WiFi Analyzer
- External Status LEDs
- Integrated Internal Status Display
BENEFITS
- Operation up to 3 miles with good line of sight and up to 900 Mbps throughput
- No driver needed. Automatic peer to peer communications
- Strong Wireless data security
- Remotely change device configuration or update firmware from anywhere on the network
- Up to 100meter (300’) cable from the PoE inserter to antenna
- Appears to network devices as if an Ethernet cable has been installed between the 2 network nodes.
- Passes DHCP, VOIP Packets, VLAN Packets and supports multiple MAC addresses
- Up to 4 Virtual AP with custom SSID, VLAN Tag per SSID
- Supports VPN Pass Through
- Built in WiFi analyzer to show spectrum usage
- Indicates Sys Power, 2.4GHz and 5GHz Wireless
- Built in status display: Shows Wireless Channel (H), IP Address (A) and Signal Strength (P)
Antenna Physical Dimensions (L x W x D)
- 260mm x 85mm x 58mm
- 10.2” x 3.3” x 2.3”
Complete System Weight
- 1 kg (2.2 lbs)
Technical Description
- Data Rates
- up to 900Mbps (80Mhz Channel)
- up to 450Mbps (40Mhz Channel)
- up to 225Mbps (20Mhz Channel)
- Standards
- IEEE802.11a/n/ac, 802.3az, 802.3u
- Power Requirements
- PoE Inserter: 100-240VAC 50/60Hz Input
- EZ-Bridge® : 48V 802.3af or 48V Passive PoE
- 12VDC to Aux DC Connector Input
- Average Power Consumption: 5W
- Regulatory Certifications
- FCC Part 15 / UL
- RF Frequency Bands
- 5180 ~ 5825 MHz
- Modulation Technology
- 802.11ac: OFDM 256QAM
- 802.11n: OFDM 64QAM
- Receive Sensitivity (Typical)
- 802.11ac: -85 dBm
- 802.11n: -88 dBm
- 802.11a: -90 dBm
- EVM – Error Vector Magnitude
- 802.11ac: <-32 dB
- 802.11n: <-28 dB
- 802.11a: < -25 dB
- Transmit Power
- 25dBm 316mW Max
- Antenna
- 5GHz 15dBi MIMO Panel Antenna, 60deg Beamwidth
- Operation Mode – Bridge or Router
- Access Point Mode, Repeater Mode (Client)
- Interface
- 10/100/1000Mbps Shielded RJ-45 Port x 2
- IP Configuration
- Static or Auto configuration using DHCP Client
- Security
- MAC Address Filtering, 128bit WEP/WPA encryption, Hide SSID in beacons
- Management Configuration
- Web-based configuration (HTTP)
- Firmware Upgrade
- Upgrade firmware via web browser
- Operating Temperature
- -30°C to +55°C (-22°F to 131°F)